| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE UNLOCK BUTTON ON THE BACK OF THE MACHINE. SLIDE THE BUTTON TO OPEN.
|
| 2 |
|
LIFT UP ON THE BODY TO DISCONNECT IT FROM THE BASE.
|
| 3 |
|
LAY THE NECK DOWN PARALLEL TO THE BASE.
|
| 4 |
|
FLIP THE BASE OVER. REMOVE THE 7 SCREWS.
| Screwdriver-phillips |
|
|
| 5 |
|
FLIP THE BASE BACK OVER AND PULL UP ON BASE COVER TO REMOVE IT.
|
| 6 |
|
REMOVE THE 2 SCREWS HOLDING BRUSH MOTOR.
| Screwdriver-phillips |
|
|
| 7 |
|
PULL BRUSH MOTOR FROM THE BASE.
|
| 8 |
|
SLIDE THE BELT OFF THE BRUSH MOTOR.
|
| 9 |
|
DISCONNECT ALL THE WIRE CONNECTORS FROM THE BRUSH MOTOR. RECORD WIRE SEQUENCE FOR REINSTALLING BRUSH MOTOR.
|
| 10 |
|
PUSH IN TAB ON CARBON BRUSH WHILE PULLING WIRE OUT.
| Screwdriver-flat tip |
|
|
| 11 |
|
PULL THE SPRING AND CARBON BRUSH OUT OF MOTOR.
|
| 12 |
|
THE CARBON BRUSH IS NOW OUT OF THE BRUSH MOTOR.REPEAT STEPS 10 AND 11 FOR THE OTHER CARBON BRUSH.
|
| 13 |
|
REVERSE STEPS 1 THRU 11 TO INSTALL NEW CARBON BRUSHES. NOTE: WHEN INSTALLING NEW BRUSHES, PUSH SPRING DOWN AND HOLD IT, SLIDE THE METAL TAB ON WIRE OVER SPRING UNTIL IT CLICKS IN PLACE.
| Screwdriver-flat tip |
|
|